Products

HIGH COUNTRY TEK - Ramping Valve Controller, MVP-R Series

The MVP-R is a ramping valve controller housed in an 18mm DIN connector body. The controller provides adjustable ramp times and current levels LED indicators on the module provide an overview of the operating status. System configuration is accomplished through a clip-on infrared adapter, without removing or opening the connector body. All settings are stored in permanent memory within the unit. The unit is prewired and permanently sealed.

Application Information:

  • Easily configured using the SAM software or our Hand Held Interface
  • LED indication of Status and Output Current
  • Standard, permanently sealed DIN 43650 Form A connector body
  • Selectable dither frequency up to 300 Hz
  • Adjustable current limited output with short circuit protection
  • Output limits are independently adjustable
  • Adjustable ramp up and ramp down times (RP1 has ramp up only)
  • Pre-wired 18 AWG TPE cable
  • Microprocessor controlled for consistent, reliable performance

Operating Specifications:

Item MVP-R
Supply Voltage 9 to 32VDC
Supply Current Isol + 20mA
Output Current "-06A" 600mA or "-12A" 1.2A or "-25A" 2.5A Maximum
Solenoid Resistance 2 Ohms Minimum
Reference Voltages +5V @ 2mA
Dither Settings Off, 30, 33, 38, 43, 50, 60, 75, 100, 150, 300 Hz
Ramp Time 0.0 to 120.0 Seconds
Analog Input Range "C1V"  0 to 10V, "C2A" 0 to 20mA
Analog Input Impedance 20 K Ohms
Operating Temperature Range -40 to +85 Deg. C
Enclosure Glass filled Polyamide
IP Rating IP67


Part Numbers:

Part Number Description
MVP-RP1-06A-10F Ramp Up Only, 600mA max output, 10ft cord
MVP-RP1-12A-10F Ramp Up Only, 1.2A max output, 10ft cord
MVP-RP1-25A-10F Ramp Up Only, 2.5A ;max output, 10ft cord
MVP-RP2-06A-10F Ramp Up/Down, 600mA max output, 10ft cord
MVP-RP2-12A-10F 0-10V input, 1.2A max output, 10ft cord
MVP-RP2-25A-10F 0-20mA input, 2.5A max output, 10ft cord

For custom cord lengths replace -10F with -xxF where xx = length in feet.